Ipx Parameters (Default Profile) Screen; System Configuration Screens - Netopia R7200 User Reference Manual

IPX parameters (default profile) screen
If you are using RFC1483 datalink encapsulation, the IPX Parameters (Default Profile) screen allows you to
configure various IPX parameters for SDSL connections established without an explicitly configured connection
profile:
NetBios Packet Forwarding:
Path Delay:
Incoming Packet Filter Set...
Outgoing Packet Filter Set...
Incoming SAP Filter Set...
Outgoing SAP Filter Set...
Periodic RIP Timer:
Periodic SAP Timer:
For details on setting up IPX Parameters see
"Security" on page 14-1.
System configuration screens
You can connect to the Netopia R7200's system configuration screens in either of two ways:
By using Telnet with the Router's Ethernet port IP address
Through the console port, using a local terminal (see
page 6-3)
You can also retrieve the Netopia R7200's configuration information and remotely set its parameters using the
Simple Network Management Protocol (see
Open a Telnet connection to the router's IP address; for example, "192.168.1.1."
IPX Parameters (Default Profile)
"IPX Setup" on page
"SNMP" on page
WAN and System Configuration 8-9
Off
10
<<NONE>>
<<NONE>>
<<NONE>>
<<NONE>>
60
60
11-1. For details on setting up Filter Sets see
"Connecting a console cable to your router" on
13-12).