Table of Contents
Advertisement
8-2 Administration Guide
WAN Configuration
To configure your Wide Area Network (WAN) connection, navigate to the WAN Configuration screen from the Main
Menu and select WAN Configuration, then WAN (Wide Area Network) Setup.
The DSL Line Configuration screen appears.
Circuit Type...
Signaling Mode...
Cell Format...
Unused Cell Format...
Data Link Encapsulation...
RFC1483 Mode...
PPP over Ethernet (PPPoE):
Display/Change Circuit...
Add Circuit...
Delete Circuit...
Select Circuit Type and from the pop-up menu choose the type of circuit to which you will be connecting.
The circuit type defaults to Auto-detect. If you accept the default, the device attempts to detect the type of
circuit to which you are connecting and self-configure its parameters accordingly.
If the device is unable to detect the circuit type, you can choose the type that your service provider
speciifes: Multimode, T1.413, G.dmt/G.lite, or ADI.
Your service provider should supply you with the appropriate information about the type and capabilities of
the access concentrator equipment they use.
Select Signalling Mode and from the pop-up menu choose either Echo Cancellation or the default FDM
(Frequency-Division Multiplexing). This setting must match the format used by your service provider. FDM is
the most common, so you probably do not need to change it unless your provider specifically tells you to do
so.
If you selected Multimode as the circuit type, toggle Trellis Coding Enabled to either On or Off. For any
other circuit type, this option does not appear.
Main
Menu
ADSL Line Conf+--------------+
WAN
Configuration
+--------------+
| Multimode
| T1.413
| G.dmt/G.lite |
| ADI
| Auto-detect
+--------------+
Scrambled
Idle
RFC1483
Bridged 1483
Off
WAN
Setup
|
|
|
|
Advertisement
Table of Contents
