Table of Contents
Advertisement
8-12 Administration Guide
The IP Profile Parameters screen displays different options depending on your choice of Data Link
Encapsulation method. The screen shown below is for a PPP connection.
Note: For IP Profile Parameters for the VPN Data Link Encapsulation methods – ATMP, PPTP, and IPsec – see
"Virtual Private Networks (VPNs)" on page
Address Translation Enabled:
IP Addressing...
Negotiate LAN IP Addr/Mask:
Remote IP Address:
Remote IP Mask:
Filter Set...
Remove Filter Set
RIP Profile Options...
Return/Enter to select <among/between> ...
Configure IP requirements for a remote network connection here.
7.
Toggle or enter the IP Parameters you require.
The Netopia 4741 allows a central site router to supply an entire IP subnet, rather than a single IP
address. If the applicable Connection Profile specifies an unnumbered, non-NAT connection and Nego-
tiate LAN IP Addr/Mask is set to On, PPP will attempt to negotiate both an IP Address and subnet
mask.
Once the router has reconfigured the address serving pool only to conform to the negotiated subnet,
you can adjust the base or extent of the pool and reboot the router. Your adjustments will not be over-
written when the connection is next renegotiated because the router only reconfigures the address
serving pool if it lies outside the negotiated subnet.
The router does not adjust any address serving parameters other than the base and extent of the
address serving pool. This allows you to otherwise configure address serving as you please using the
normal address serving configuration items. For example, if you disable address serving, the router
will not enable address serving when it reconfigures the address serving pool.
This toggle is visible only if the profile's Data Link Encapsulation is set to PPP, the Address Translation
Enabled toggle is set to No and IP Addressing is set to Unnumbered. The default value is No.
RIP Profile Options is not visible if Negotiate LAN IP Addr/Mask is set to Yes and the Remote IP Mask
is set to 0.0.0.0.
For more information, see
8.
Return to the Add Connection Profile screen by pressing Escape. Select COMMIT and press Return. Your
new Connection Profile will be added.
11-1.
IP Profile Parameters
"Connection Profiles" on page 9-25
No
Unnumbered
No
0.0.0.0
0.0.0.0
in
Chapter 9, "IP Setup."
Advertisement
Table of Contents
