Binding Map Lists And Server Lists; Ip Profile Parameters - Netopia 4741 2A4NA Administration Manual

Binding Map Lists and Server Lists

Once you have created your map lists and server lists, for most Netopia Router models you must bind them to
a profile, either a Connection Profile or the Default Profile. You do this in one of the following screens:
the IP profile parameters
the IP Parameters (WAN Default Profile)
the Binding Map Lists and Server Lists
IP profile parameters
To bind a map list to a Connection Profile, from the Main Menu go to the WAN Configuration screen then the
Display/Change Connection Profile screen. From the pop-up menu list of your Connection Profiles, choose the
one you want to bind your map list to. Select IP Profile Parameters and press Return.
Main
Menu
The IP Profile Parameters screen appears.
Address Translation Enabled:
IP Addressing...
NAT Map List...
NAT Server List...
Local WAN IP Address:
Remote IP Address:
Remote IP Mask:
Filter Set...
Remove Filter Set
RIP Profile Options...
Configure IP requirements for a remote network connection here.
screen (see below) of the Connection Profile configuration menu
screen (see
screen (see
WAN
Configuration
IP Profile Parameters
Multiple Network Address Translation 10-23
page 10-25) of the Default Profile configuration menu
page 10-23)
Display/Change
Connection Profile
Yes
Unnumbered
Easy-PAT List
Easy-Servers
206.1.1.6
127.0.0.2
255.255.255.255
Basic Firewall
IP Profile
Parameters