Table of Contents
Advertisement
8-24 Administration Guide
You should pick a time server close to your location, if possible. Lists of public time servers supported by
corporations, governments, and educational institutions are available by searching the Internet.
Enter a Time Server Host Name or IP Address. This may be in the form hostname.domainname or in
dotted quad (xxx.xxx.xxx.xxx) notation. The default address 204.152.184.72 is a public NTP server and
may be suitable for your needs, or you can supply your own choice.
From the pop-up Time Zone menu, select your time zone.
Set the NTP Update Interval to some convenient interval such as every day (24:00) or every few hours.
From the pop-up System Date Format menu select the date format used in your region: MM/DD/YY,
DD/MM/YY, or YY/MM/DD.
From the pop-up System Time Format menu select your preferred time notation: AM/PM or 24hr.
If you do not want to use NTP for date and time setting, you can toggle it to Off. In that case, you can set the
clock manually (Remember that the clock reverts to a default date and time any time the device is rebooted, so
you must reset the clock manually.):
From the pop-up System Date Format menu select the date format used in your region: MM/DD/YY,
DD/MM/YY, or YY/MM/DD.
Enter the Current Date in whatever format you have chosen.
From the pop-up System Time Format menu select your preferred time notation: AM/PM or 24hr.
Enter the Current Time in whatever format you have chosen.
From the AM or PM pop-up menu, select AM or PM.
Console configuration
You can change the default terminal communications parameters to suit your requirements.
To go to the Console Configuration screen, select Console Configuration in the System Configuration screen.
Baud Rate...
SET CONFIG NOW
Console Configuration
57600
CANCEL
Advertisement
Table of Contents
