Table of Contents
Advertisement
IP setup
These screens allow you to configure your network's use of the standard networking protocols:
IP: Details are given in
Filter sets
These screens allow you to configure security on your network by means of filter sets and a basic firewall.
Details are given in
IP address serving
These screens allow you to configure IP address serving on your network by means of DHCP, WANIP, and BootP.
Details are given in
Date and time (Network Time Protocol)
You can set the system's date and time in the Set Date and Time screen.
Select Date and Time in the System Configuration screen and press Return. The Set Date and Time screen
appears.
NTP (Network Time Prot.) Enabled:
Time Server Host Name/IP Address
Time Zone...
NTP Update Interval (HHHH:MM)
System Date Format:
System Time Format:
The Netopia 4741 uses Network Time Protocol (NTP) by default to set the date and time automatically. You may
want to modify the default settings for your own environment.
NTP takes effect five minutes after the device boots. At that time NTP attempts to connect to a central Time
Server and set the device's clock. If the device is rebooted for any reason, the time settings revert to an
internal default date and time for five minutes until NTP can reconnect to its time server and reset the clock.
"IP Setup" on page
"Security" on page
12-1.
"IP Address Serving" on page
Set Date and Time
9-2.
9-10.
On
204.152.184.72
GMT -8:00 Pacific Standard Time
1:00
MM/DD/YY
AM/PM
WAN and System Configuration 8-23
Advertisement
Table of Contents
