Tecnosicurezza TechMaster User Instructions page 7

TechMaster
= access to Manager menu, Manager ovr menu (if configured) Change code menu, Time
menu, Configuration menu and Master menu.
= System info and time and date info
= Exit and back to the main menu
= Master menu
User properties and default codes
Users can be programmed for opening with code only, code + Dallas key or with Dallas key only.
It is also possible to set a dual mode opening: in this case, entering the two users codes is
required to open the lock.
Default codes are:
Master: 1-2-3-4-5-6-7-8.
Manager: 123456.
Users from 02 to 90: 02-020202, 03-030303, and so on. They always open with time delay if
programmed.
Override users: through to the setup software, it is possible to configure users in between 10
and 90 (10-101010, 11-111111, and so on) as override users. They always open without time
delay.
For class C, all users codes, including Master and Manager, are 8-digits type.
Users from 02 to 90 and Override users have a default code such as 02-02020202, 03-03030303,
and so on.
The table below reports the functions for the main users.
Master
Access to Master Menu
Set time and date
Set Time Lock periods
Audit download
Manager Management
Enable/disable OTCs
Change code
PC Link
Override manager
Access to Ovr. Manager menu
Override users management
Code changing
IU_TechMaster_07_eng
Manager
Access to Manager Menu
Standard users management
Override users management
Set time delay
Set variable time delay
PC Link
Audit download
Opening
Code changing
Set opening extension
Set immediate time lock
Configuration menu
Install/remove locks
Set display contrast
Change language
User instructions
7 of 28