Tecnosicurezza TechMaster User Instructions page 25

TechMaster
Press until the LCD displays:
Press to confirm. LCD displays:
Enter Master code. LCD displays:
If Dynamic codes have been activated, along with the deletion of all static codes
(including the Master code), it is possible to directly access the menus I/O interface
configuration and I/O interface removal by entering a dynamic code for the user I/O
CONFIGURATION USER.
For further information, see the paragraph Dynamic codes activation with static codes
deleting, page 18.
Display contrast
Power up the keypad. Access Configuration Menu. LCD displays:
Press until the LCD displays:
Press . LCD displays:
Enter a contrast level (between 1 and 9) and press
LCD displays:
If Dynamic codes have been activated, along with the deletion of all static codes
(including the Master code), it is possible to access the Display contrast menu by pressing
and holding .
For further information, see the paragraph Dynamic codes activation with static codes
deleting, page 18.
Temporary restoring of the display contrast
This option can only be accessed after activating the dynamic codes without deletion of
the static codes.
Power up the LCD. Press and hold
keypad firmware version.
Keep pressed for 3s: LCD contrast level is automatically set to "3"
regardless the last contrast value set and it remains at "3" until the
LCD is kept ON.
Keypad Language
Power up the keypad. Access Configuration Menu. LCD displays:
IU_TechMaster_07_eng
to confirm.
until the LCD displays the
User instructions
REMOVEE I/O
INTERFACE
MASTER CODE
X X X X X X X X
OPERATION DONE
INSTALL
LOCKS
DISPLAY
CONTRAST
ADJUST
CONTRAST
X
OPERATION DONE
INSTALL
LOCKS
25 of 28