Fingerprint Module Test; Fingerprint Device Information Check; Appendix; Default Values For Parameters - IDTECK Star FINGER006 User Manual
Fingerprint identification proximity / pin reader
Hide thumbs
Also See for Star FINGER006:
- User manual (48 pages) ,
- Quick installation manual (18 pages)
Table of Contents
Advertisement
12.4.18 FINGERPRINT MODULE TEST
18. FP TEST
TEST PASSED!!!
12.4.19 FINGERPRINT DEVICE INFORMATION CHECK
19. DEVICE INFO
FIM2030-HD
13. Appendix
13.1 Default Values for Parameters
No
1
READER #1 Operation Mode
2
READER #2 Operation Mode
3
READER #1 Keypad Input Limit
4
READER #2 Keypad Input Limit
5
Output Mode
6
Key Output Mode
7
Output Type
8
LCD Display
FP Test allows you to test the fingerprint module on your
FINGER006. To begin the test, press <ENT>. If the test is
successful, the "TEST PASSED" message will be displayed. If
the test is unsuccessful, the LCD will display the "TEST
FAILED" message. If that is the case, try again. If the problem
persists, please contact your local IDTECK dealer for
assistance or service.
Device Info shows you the model name of the fingerprint
module on your FINGER006.
Parameter
46
Default Value
ID(RF), FP(PW)
ID ONLY
USE
USE
WEIGAND
8BIT BURST
NOMAL MODE
STATUS
Advertisement
Table of Contents
