Rf Pin Input; Key Output Mode; Output Type; Stand Alone - IDTECK Star FINGER006 User Manual

12.2.5 RF PIN INPUT

5. RF PIN INPUT
ENABLE
5. RF PIN INPUT
- > DISABLE

12.2.6 KEY OUTPUT MODE

6. KEY OUTPUTMODE
8BIT BURST
6. KEY OUTPUTMODE
4BIT BURST

12.2.7 OUTPUT TYPE

7. OUTPUT TYPE
NORMAL MODE
7. OUTPUT TYPE
EXTENSION

12.2.8. STAND ALONE

8. STAND ALONE
NOT USE
8. STAND ALONE
USE
RF Pin Input allows you to decide whether to enable or
disable PIN (or RF card number) Input via the keypad. If not
configured, PIN Input is enabled by default.
Caution: If you choose "Disable", you cannot gain access via
password input when using RF+PW mode.
You can change the Output Mode when you press function
keys
4BIT Burst: 4bit burst will be output when you press
function keys
8BIT Burst: 8bit burst will be output when you press
function key
You can select the OUTPUT TYPE between NORMAL
MODE and EXTENSION MODE.
NORMAL MODE: If a registered ID or/and a fingerprint is
entered, FINGER006 outputs ID data only.
EXTENSION MODE: If an ID or/and a fingerprint is
entered, FINGER006 outputs OK or ERROR signal and ID
data.
You can choose whether to use a standalone function or not
by using <4> or <6> key. After changing set values, press
<Enter>key to save the changed values
Caution: When you select "USE", FINGER006 waits for a
reply of a controller. But if there is no reply after a lag,
verification process is denied. (Default is <NOT USE>)
When the controller is waiting for the verification signal, LCD
shows "RD CERTIFYNG" message.
33