List Of Installer Parameters - DeDietrich IX 245-130 Installation, User And Service Manual

Tab.53 Temps / mode CH1 – Temps / mode CH2 – Temps / mode CH3 menu
Parameter number
Heating Heating Heating cir­
circuit 1 circuit 2 cuit 3
700 1000 1300
710 1010 1310
712 1012 1310
Tab.54 Structure of the installer menu
Menu
Installer
Tab.55 Operator section menu
Parameter Parameter
number
24 Lighting
29 Units
7702684 - v04 - 05092019
Parameter Description
The control unit is installed on the boiler:
Off : heating is deactivated.
Timed : the heating is dependent on the timer pro­
gram.
Reduced : heating is in permanent reduced mode.
On : heating is in permanent reduced mode.
The control unit is installed as a room temperature
Operating
control system:
mode
Off : the boiler starts up when the room tempera­
ture falls below the frost protection set point.
Timed : the heating is dependent on the timer pro­
gram.
Reduced : the room temperature set point is the
reduced set point (Parameters 712, 1010, 1310)
On : the room temperature set point is the comfort
set point (Parameters 710, 1010, 1310)
Comfort
setpoint
Reduced
temp setpoint
10.1.4

List of installer parameters

Sub-menu
Operator section
Temps / mode CH1
Temps / mode CH2
Temps / mode CH3
Temps / mode hot water
Boiler Settings
Solar
Configuration
Error
Service/special operation
State
Diagnostics heat generation
Burner control
Description
Off
Temporarily
Permanently
°C, bar
°F, PSI
10 Settings
Factory setting
On
20 °C
16 °C
Factory set­
ting
Temporarily
°C, bar
IX 87