Tab.22
Settings on boiler 2 (slave boiler)
Parameter number
5710
6600
6640
Tab.23
Configuration of the master boiler in a cascade
Parameter num
Parameter
ber
6200
Save sensors
6630
Cascade master
6640
Clock mode
Tab.24
Cascade configuration of the slave boilers
Parameter num
Parameter
ber
5710
Temps / mode CH1
6600
Device address
6640
Clock mode
7702684 - v04 - 05092019
4. Set the following parameters on boiler 2:
Parameter
Temps / mode CH1
Device address
Clock mode
6.3.5
1. Access the installer parameters of the master boiler.
2. Set the following parameters on the master boiler:
Adjustment required
Yes
Always
Autonomously
3. Access the installer parameters for the slave boiler(s):
4. Set the following parameters on the slave boiler(s).
Adjustment required
Off
2...3...4...
Slave with remote setting
Adjustment required
Off
2
Slave without remote setting
Configuration for a master boiler and slave boilers
Important
Remember to deactivate Heating circuit 1 so that the
thermostatic input on terminal block M1 (1-2) is not taken into
account.
6 Connecting diagrams
Description
Saving any modifications made.
The setting will revert automatically
to No immediately after the adjust
ment.
Identification master boiler
Cascade master boiler clock setting
Description
Cascade activation
Setting the slave boiler clock with a
master boiler
IX
53