Safety; General Information; Duty Of Information - Teka Mistral Plus Operating Instructions Manual

2.

Safety

2.1.

General information

The Mistral is built according to the state of technology and the recognised safety-relevant rules.
Nevertheless dangers for the user or third and/or impairments of the Mistral and other real values can
develop with its use, if:
–
it is operated by not trained or not instructed personnel,
–
it is not intended used,
–
it is inappropriately held or waited.
2.2.

Duty of information

For your security!
As operator of the filter system please, consider absolutely the data given in the CE manufacturer
explanation, CE - declaration of conformity, the data and information in the user manual and in particular the
operating and safety instructions.
Residual risk
Filter systems and suction units contain inflammable construction parts (filter material, seals, plastic parts,
etc.). Consider in your work place evaluation after the law for employee protection (AschG the residual risk of
a case of fire. It is important to have the approval of us with changes in the use of the filter system in
writing.
CE – Declaration of conformity
As a rule we deliver the filter system with a CE - declaration of conformity. When assembled with other parts
it becomes a higher - ranking filter system for which you, as operator, have the duty to make a danger
analysis and you must provide a CE - declaration of conformity for the whole filter system.
Duty of information
Sparks, cigarette stubs or similar may not be sucked into the filtering device.
Our plants may be used only as described in the operating manual and as intended. Changes in the use
require our express written permission.
Each use going beyond it is not considered as intended, the manufacturer / supplier can not be made liable
for developing damages which result from it. The risks carries the operator.
Intended use of the filter system(s) / plant
It is not allowed sucking off dust, smoke, gases and media which do not correspond with the chapter
2.3 in this operating instruction. The media exhausted may be classified in no dust explosion class
(St-Class).
Start-up maintenance work and service
Refer to maintenance and safety instructions in the operating manual.
All repair and maintenance work may only be carried out with complete stand still of the machine/plant
(separate all poles by switching off from the mains, pull the plug out of the socket). Only trained and
authorised personnel may operate, make maintenance work service at the machine/plant. Work within the
electrical range may be implemented by authorised specialists only!
The plant must at least 1x annually be examined per AAV §16 Abs. 8.
Operating Instructions Mistral (Plus), Mistral Eco (Plus), Mistral Super Plus 110 and 230V vers. 4.10 Page 9 of 47