Maintenance; General Information - Teka Mistral Plus Operating Instructions Manual

8.

Maintenance

8.1.

General information

The chapter maintenance covers the ranges servicing, visual inspection (inspection) and maintenance by the
operating personnel as well as those of the service of the Mistral by particularly trained maintenance
personnel. The arrangement of these ranges into different maintenance intervals is to facilitate the planning
of each necessary maintenance for you.
The instructions described in this chapter are to be understood as minimum recommendations. Depending
upon operating conditions expansions can become necessary, in order to remain the high quality of the
Mistral. The indicated time intervals refer to the operation hours of the Mistral indicated at the display.
Warning!
Endangerment of humans and real values possible!
By inappropriate inspection, maintenance or repair damages to property and person arising direct or in the
future are possible.
All maintenance and repair at the Mistral may be implemented only by qualified technical personnel (consider
chapter 2, security).
References to repairs and orders of spare parts please take from the product description and spare parts list.
Information!
For the preservation of the warranty claim the regular work for the maintenance must be proven by
maintenance and operating personnel by record.
Use only approved original spare parts!
With the use of unapproved spare or replacement parts and operational funds the Trotec Produktions- u.
Vertriebs GmbH does not take over warranty!
Provide for careful and safe environmental disposal.
Reference!
To avoid damages at the Mistral pay attention to an normal disassembly and assembly of construction units.
With all dismantle and disassembling applies therefore in principle:
–
Mark parts.
–
Note the installation position and place.
–
Disassemble, clean and keep building groups separately.
After repairs applies in principle:
–
Control all bolt connections for tightness.
–
Control all hose and fittings as well as connections for tightness.
Reference!
If the disassembly of protection device is necessary for maintenance, the reattachment and the examination
of the protection device has to take place immediately after conclusion of the work.
Consider also the safety references in section 2,8, safety references to the maintenance as well as the
referring to special danger kinds in section 2.9.
Operating Instructions Mistral (Plus), Mistral Eco (Plus), Mistral Super Plus 110 and 230V vers. 4.10 Page 30 of 47