Dimm Installation; Dimm Removal - Supermicro SuperServer SYS-520P-WTR User Manual

DIMM Installation

1. Insert the desired number of DIMMs
into the memory slots based on the
recommended DIMM population table on
page 38.
2. Push the release tabs outwards on both
ends of the DIMM slot to unlock it.
3. Align the key of the DIMM module with the
receptive point on the memory slot.
4. Align the notches on both ends of the
module against the receptive points on the
ends of the slot.
5. Press the ends of the module straight
down into the slot until the module snaps
into place.
6. Press the release tabs to the lock positions
to secure the DIMM module into the slot.

DIMM Removal

Press both release tabs on the ends of the
DIMM module to unlock it. Once the DIMM
module is loosened, remove it from the
memory slot.
Chapter 3: Maintenance and Component Installation
MH2
BT1
BIOS
LICENSE
I-SATA0~3
MH9
MH6
JL1
FAN6
Release Tabs
40
COM1
UID-SW
UID-LED
VGA
MH1
USB4/5(3.0)
LAN2
LAN1 USB0/1
IPMI_LAN
MH16
MH15
JBT1 CMOS CLEAR
I-SATA4~7
JRK1
X12SPW-TF/F
MH3 REV: 1.10
DESIGNED IN USA
CPU
MH4
1
MH5
FAN2
FAN4 FAN1
Notches
Press both ends
straight down into
the memory slot.