Peak Values (3.6.) - Siemens SITRANS L Operating Instructions Manual

To assign a diagnosis to a particular event via the handheld programmer:
1. Go to Enable (3.4.1.) and select Yes to enable Condensed Mode.
2. Go to Event Index (3.5.1.) and enter the event index number corresponding to a particular
event.
3. Go to Event Diagnosis (3.5.3.) and choose a Diagnosis option from the table above.
To assign a status to a particular event via SIMATIC PDM:
1. Go to Level Meter > Diagnostics > Condensed Status Setup, and select Yes to enable
Condensed Status Mode.
2. Go to Level Meter > Diagnostics > Condensed Status.
3. Select the Diagnosis line for the selected Event, then choose a Diagnosis option from the
associated pull-down menu.
7.4.9

Peak values (3.6.)

To view via SIMATIC PDM:
Open the menu View – Device Diagnostics, select Device Status, and click on the tab
Device Status. For more details see Device Status (Page 81).
Min. Measured Value (3.6.1)
The minimum recorded Sensor value, reported in units defined in Unit (2.3.1.).
Max. Measured Value (3.6.2.)
The maximum recorded Sensor value, reported in units defined in Unit (2.3.1.).
Minimum Output Value - AIFB1 (3.6.3.)
The minimum recorded Output Value from the Analog Input Function Block 1.
Maximum Output Value - AIFB1 (3.6.4.)
The maximum recorded Output Value from the Analog Input Function Block 1.
Minimum Output Value - AIFB2 (3.6.5.)
The minimum recorded Output Value from the Analog Input Function Block 2.
Maximum Output Value - AIFB2 (3.6.6.)
The maximum recorded Output Value from the Analog Input Function Block 2.
SITRANS LR200 with PROFIBUS PA
Operating Instructions, 07/2021, A5E32337680-AF
Parameter assignment
7.4 Diagnostics (3.)
121