Cable-15-1M; Communicating With Opto-22 Snap-B3000-Enet - Galil Motion Control CDS-3310 User Manual

CABLE-15-1m

The Cable-15-1m is a cable with a 15 pin high-density connector at one end and flying leads at the
other that is used to break out the J2 connector on the CDS-3310. This 15 pin cable provides an
interface to the encoder and hall sensors. This section lists the color coding for 15 pin cable. (2 meter
cables are also available with -2m designation).
15 Pin Break-out Cable (for J2) Color Coding
Pin
1
2
3
4
5
6
7
8

Communicating with OPTO-22 SNAP-B3000-ENET

The controller is connected to OPTO-22 via handle F. The OPTO-22's IP address is 131.29.50.30.
The Rack has the following configuration:
98 • Appendices
Color
Black
Black/White
Brown
Brown/White
Red
Red/White
Orange
Yellow
Digital Inputs
Digital Outputs
Analog Outputs (+/-10V) Module 3
Analog Inputs (+/-10V)
Instruction
#CONFIG
IHF=131,29,50,30<502>2
WT10
JP #CFGERR,_IHF2=0
JS #CFGDOUT
JS #CFGAOUT
JS #CFGAIN
MBF = 6,6,1025,1
EN
#CFGDOUT
MODULE=2
CFGVALUE=$180
NUMOFIO=4
JP #CFGJOIN
Pin
Color
9 Green
10 Blue
11 Purple
12 Silver
White
13
14 Pink
15 Light Green
Module 1
Module 2
Module 4
Interpretation
Label
Establish connection
Wait 10 milliseconds
Jump to subroutine
Configure digital outputs
Configure analog outputs
Configure analog inputs
Save configuration to OPTO-22
End
Label
Set variable
Set variable
Set variable
Jump to subroutine
CDS-3310