String Variables; Output Of Data (Numeric And String); Sending Messages - Galil Motion Control CDS-3310 User Manual

String Variables

String variables with up to six characters may be input using the specifier, {Sn} where n represents the
number of string characters to be input. If n is not specified, six characters will be accepted. For
example, IN "Enter A,B or C", V{S} specifies a string variable to be input.
The controller, stores all variables as 6 bytes of information. When a variable is specified as a number,
the value of the variable is represented as 4 bytes of integer and 2 bytes of fraction. When a variable is
specified as a string, the variable can hold up to 6 characters (each ASCII character is 1 byte). When
using the IN command for string input, the first input character will be placed in the top byte of the
variable and the last character will be placed in the lowest significant byte of the fraction. The
characters can be individually separated by using bit-wise operations, see section Bit-wise Operators.

Output of Data (Numeric and String)

Numerical and string data can be output from the controller using several methods. The message
command, MG, can output string and numerical data. Also, the controller can be commanded to return
the values of variables and arrays, as well as other information using the interrogation commands (the
interrogation commands are described in chapter 5).

Sending Messages

Messages may be sent to the bus using the message command, MG. This command sends specified
text and numerical or string data from variables or arrays to the screen.
Text strings are specified in quotes and variable or array data is designated by the name of the variable
or array. For example:
In addition to variables, functions and commands, responses can be used in the message command.
For example:
Formatting Messages
String variables can be formatted using the specifier, {Sn} where n is the number of characters, 1 thru
6. For example:
This statement returns 3 characters of the string variable named STR.
Numeric data may be formatted using the {Fn.m} expression following the completed MG statement.
{$n.m} formats data in HEX instead of decimal. The actual numerical value will be formatted with n
characters to the left of the decimal and m characters to the right of the decimal. Leading zeros will be
used to display specified format.
For example::
If the value of the variable result is equal to 4.1, this statement returns the following:
CDS-3310
JP #NMLP
EN
MG "The Final Value is", result
MG "Input 1 is", @IN[1]
MG "The Position of A is", _TPA
MG STR {S3}
MG "The Final Value is", result {F5.2}
End
Chapter 7 Application Programming
i
45