Table of Contents
Advertisement
installation
|
24
WALL MOUNT ON / OFF SWITCH AND REMOTE RECEIVER INSTALLATION
Required for all installations - including Proflame remote controls
The Receiver must be placed inside the supplied (Low Voltage)
DO NOT INSTALL WITHIN THE CONFINES OF THE FIREPLACE.
Remote Receiver Installation
1. Install the low voltage junction box to the framing, at desired location within 9 ft. (2.7 meters) from fireplace.
2. Feed the 12 pin connector through the opening at back of junction box.
3. Connect the 12 pin connector to the back of the receiver.
4. Install the Receiver in the Low Voltage Junction box.
5. Insert the 4 AA type batteries in the battery compartment with the correct polarity (only required if no fan
control module is installed)
control module or AC adaptor is installed).
6. Place the slider into the cover plate.
1
7. Put the Receiver switch in the "OFF" position, to allow correct lineup for slider switch.
8. Make sure the Receiver and cover plate words "ON" and "UP" are on the same side.
9. Align the slider with the switch on the Receiver and couple the switch into the slider.
10. Align the screw holes.
11. Using the two (2) screws provided secure the cover plate to the Receiver.
Proflame Receiver
ON
REMOTE
OFF
Receiver 12 Pin Connector
for mV GT Systems
TH/TFTH Connections Only
6
Item
Part No.
Description
1
N/A
Slider Switch (included with wall plate)
2
911-335
Wall Plate - White
911-343
Wall Plate - Black
3
911-338/P
Remote Receiver
4
N/A
J-Box
5
910-369
Low Voltage Junction Box
6
911-032
Remote Receiver Wire Harness
24 | P36-10 Zero Clearance Direct Vent Gas Fireplace
IMPORTANT INSTALLATION NOTE:
junction type wall box and installed into the wall only.
2
1
4
3
2
10 ft. wire harness with
12 pin connector
1
5
Diagram 1
Advertisement
Table of Contents
