Table of Contents
Advertisement
46/122
Bosch Rexroth AG
Mounting and removing modules
6.4.3
Input/output modules
•
Place the necessary input/output modules vertically on the corresponding
bus base module and DIN rail until they audibly click into place.
Pay attention to the correct position.
Make sure that the device connectors for the bus base connection are situated
above the corresponding sockets on the bus base module.
Fig. 6-10
Mounting input/output modules
If you are using analog modules, mount the necessary shield connection ele-
ments.
For connecting the shield, Bosch Rexroth recommends the
IndraControl S20 shield connection set "S20-SHIELD-SET".
When using the S20-SHIELD-SET, mount the elements in the following order:
1.
Bus base module
2.
Shield bus holder
3.
Electronics module
See also
Chapter "Connecting the shield using the IndraControl S20 shield con-
nection set" on page
74.
DOK-CONTRL-S20*SYS*INS-AP02-EN-P
Rexroth IndraControl S20
Hide quick links:
Advertisement
Table of Contents
