Table of Contents
Advertisement
DOK-CONTRL-S20*SYS*INS-AP02-EN-P
Rexroth IndraControl S20
6.5
Removing modules
6.5.1
Removing connectors or cables
Removing the network con-
nector
Supply connector,
I/O connector
Removing cables
Removing the
IndraControl S20 connectors
Please refer to Chapter
page
37.
A standard tool, e.g., a bladed screwdriver with a blade width of 2.5 mm is neces-
sary for removing modules.
•
Remove the network connector, if present, according to the specifications in
the module-specific documentation.
•
Prior to module removal, also remove the connectors or cables, if present,
from the module.
–
If no cables are inserted, the connectors do not need to be removed.
–
If cables are inserted, either remove the connectors from the module or
the cables from the connectors.
The cables should only be removed from the connector if you wish to
change the wiring or no longer wish to use the connector.
See
Chapter "Removing cables from the terminal point" on page
See
Chapter "Inserting/removing a connector" on page
Bosch Rexroth AG
Mounting and removing modules
"Safety notes for mounting/removal" on
51.
47/122
61.
Hide quick links:
Advertisement
Table of Contents
