Table of Contents
Advertisement
DOK-CONTRL-S20*SYS*INS-AP02-EN-P
Rexroth IndraControl S20
If the bus base module to be removed is inside the station:
•
If possible, push the following bus base modules and any fitted modules ap-
proximately 15 mm to the right.
In doing so, disconnect the bus base module you want to remove from the fol-
lowing bus base module.
•
If it is not possible to slide the following bus base modules and modules, de-
tach the modules, and, starting at the end of the station, remove the bus base
modules.
•
Disconnect the bus base module to be removed from the connection of the
previous bus base module by sliding it approximately 5 mm to the right (A).
•
Insert a suitable tool (e.g., bladed screwdriver) into the latches on one side (B,
B1, B2) one after the other.
•
Swivel the bus base module upwards and remove it (C).
•
Push the rest of the station back to the left until the bus base modules touch
each other again.
Bosch Rexroth AG
Mounting and removing modules
49/122
Hide quick links:
Advertisement
Table of Contents
