Cisco UC500 Series Technical Training Manual page 126

Verify the configuration on the SPA525 phone.
Press the Setup button on the phone this is the button just below the Messages button.
Use the Navigation button to scroll to the Network Configuration menu option
Press the Select softkey.
Scroll down and select the Wi-Fi configuration
Press the Select softkey.
Scroll down and select the Wireless Profile
Press the Select softkey
Here you should see the pod19 profile
Select the option softkey and select edit now you will see details for the pod19 profile.
At this time you should be able to make calls using the SPA525 phone.
Configure SPA525 phones after the wizard has been run.
To configure SPA525 phones after the wizard has been run simply connect the phone into any port on
the UC520 and allowing the phone to auto register and the wireless profile will be transferred to the
phone.
1) Connect one end of an Ethernet cable to the Ethernet port on the phone and the other to an
available PoE port on the UC500 or a CE520 switch, if one is present in the community.
2) The phone will boot up and receive its SSID and profile information from the UC500
automatically. The phone reboots once it receives this information.
3) When the phone has finished rebooting, it will have the correct SSID and profile and receive an
extension.
4) Unplug the Ethernet cable from the phone and move the phone to the desired location.
5) Plug in power and Enable Wi-Fi mode on the phone.
6) Now you are ready to make calls.
Cisco Unified Communications Technical Training
LAB 7B: Wireless
Page 126 of 171