Cisco UC500 Series Technical Training Manual page 10

o Once discovery is complete (this may take up to a minute) click 'OK' to view the topology. The
progress for discovery can be seen at the bottom of the screen.
o Check the topology to ensure all the phones show up. You may or may not see the CIPC device,
depending on where your laptop is plugged in. If it is plugged into a POE port of the UC520, the
CIPC will appear. If the laptop is plugged into the back of an IP phone, the CIPC will not appear.
o Click on 'Configure -> Telephony -> Voice' on the side bar or click the 'Phone' icon on the top
menu bar. In the next steps, we will configure the various tabs – "System", "Voicemail", "SIP
Trunk", "Dial Plan" and "Users".
NOTE: It may take up to 60 seconds for CCA to load voice data. If
you see the window below, please follow the instructions in the
Cisco Unified Communications Technical Training
LAB 2: PBX, Voicemail & DialPlan
Page 10 of 171