Cisco UC500 Series Technical Training Manual page 122

Enter wireless SSIDs
1) Enter the network name (SSID) and password for the voice and data Wi-Fi network at the site,
and choose whether to broadcast the network name.
a. For the Voice network use the SSID pod19 and password of cisco123.
b. For the Data network use SSID of pod19-data and password of 12345678.
c. If the passwords are not long enough or do not match you will see a warning at the
bottom of the page.
WPA2/PSK ("personal mode" with pre-shared key) is used for wireless security.
When Broadcast network name is checked, the network name will appear in the list when
scanning for available wireless networks. By default, Broadcast network name is off
(unchecked).
The password entered here overrides the password on external APs.
2) Re-enter the password for verification.
3) Click Apply when finished.
When you click Apply, the data and voice network name (SSID) and passwords are applied to the
APs present in the community, following design guidelines for SBCS wireless voice networks. To
optimize performance, external APs always take precedence over embedded APs.
Cisco Unified Communications Technical Training
LAB 7B: Wireless
Page 122 of 171