Step 1 - Hardware Installation - NetComm NB4 User Manual

Step 1 - Hardware Installation

To connect your modem, follow the step by step instructions below:
1. Connecting the ADSL cable.
Connect one end of the provided phone cable to the port labeled DSL on the Rear Panel of
the device. Connect the other end to your wall phone jack.
2. Connecting the Ethernet cable.
Connect one end of the ethernet cable to the network port on your PC and the other end of
the cable to the ethernet port of the NB4 ADSL Modem Router.
3. Attach the power connector.
Connect the AC power adapter to the Power connector on the back of the device and plug
in the adapter to a wall outlet or power strip. Switch the power on to the NB4.
4. Power up your systems.
Turn on and boot up your computer.
After completing the above, refer to the appropriate operating system section to configure
your computer.
NOTE: At this stage, if your ADSL line is active the ADSL Light should stay perma-
nently ON - if it is blinking, then an ADSL Service has not been detected.
NB4 User Guide
8
YML733Rev1
www.netcomm.com.au