Appendix B: Cable Connections; Rj-45 Network Ports; Twisted Pair Cables - NetComm NB4 User Manual

Adsl 4-port modem router
Hide thumbs Also See for NB4:
Table of Contents

Advertisement

Appendix B: Cable Connections

Appendix B: Cable Connections
Appendix B: Cable Connections
Appendix B: Cable Connections
Appendix B: Cable Connections
This cable information is provided for your reference only. Please ensure you only connect
the appropriate cable into the correct socket on either this product or your computer.
If you are unsure about which cable to use or which socket to connect it to, please refer to the
hardware installation section in this manual. If you are still not sure about cable connections,
please contact a professional computer technician or NetComm for further advice.

RJ-45 Network Ports

RJ-45 Network Ports can connect any networking devices that use a standard LAN interface,
such as a Hub/Switch Hub or Router. Use unshielded twisted-pair (UTP) or shield twisted-pair
(STP) cable to connect the networking device to the RJ-45 Ethernet port. Depending on the
type of connection, 10Mbps or 100Mbps, use the following Ethernet cable, as prescribed.
10Mbps: Use EIA/TIA-568-100-Category 3, 4 or 5 cable.
100Mbps: Use EIA/TIA-568-100-Category 5 cable.
Note:
Note:
To prevent loss of signal, make sure that the length of any twisted-pair
To prevent loss of signal, make sure that the length of any twisted-pair
Note:
Note:
Note:
To prevent loss of signal, make sure that the length of any twisted-pair
To prevent loss of signal, make sure that the length of any twisted-pair
To prevent loss of signal, make sure that the length of any twisted-pair
connection does not exceed 100 metres.
connection does not exceed 100 metres.
connection does not exceed 100 metres.
connection does not exceed 100 metres.
connection does not exceed 100 metres.

Twisted pair cables

Figures 1 and 2 illustrate the use of straight-through and crossover twisted pair cables along
with the connector.
YML733 Rev1
www.netcomm.com.au
RJ-45 Connector
Pin Assignment
1
2
3
6
4,5,7,8
Figure 1
Figure 2
Normal Assignment
Input Receive Data +
Input Receive Data -
Output Transmit Data +
Output Transmit Data -
Not used
RJ-45 plug
attached to cable
NB4 User Guide
63

Advertisement

Table of Contents
loading

Table of Contents