Back Panel Ports; Resetting Factory Defaults - NetComm NB4 User Manual

Back Panel Ports

Back Panel Ports Back Panel Ports
Back Panel Ports Back Panel Ports
RJ11 for ADSL
connection to
telephone line
ADSL
ETHERNET
RESET
DC

Resetting Factory Defaults

The restore to factory defaults feature will set the ADSL Router to its factory default configura-
tion by resetting the ADSL Router. You may need to place the ADSL Router into its factory
defaults; if the configuration has changed, you lose the ability to configure the ADSL Router
via the web interface, or following a software upgrade. To reset the ADSL Router:
■
Ensure that your ADSL Router is powered on (for at least 10 seconds).
■
Use a paper clip or a pencil tip to depress the reset button for five seconds and release. At
this point, the reset is in progress. Do not power off the unit at this point.
■
When indicator lights return to steady green, reset is complete. The default settings are
now restored.
NB4 User Guide
16
4 x RJ45 Ports for
10/100 Ethernet
LAN connection
Telephone jack (RJ-11) to connect to your Telephone Wall Socket (ADSL
line).
4 x 10/100 Base-T Ethernet jack (RJ-45) to connect to your Ethernet
Network card or Ethernet Hub / Switch.
To reset your ADSL Router to factory default settings. (All customised
settings that you have saved will be lost!)
Please refer to the section below on how to use the reset function.
Connect the Power Adapter that comes with your package.
Reset Power jack for
factory AC power
defaults adaptor
www.netcomm.com.au
YML733Rev1