Returning from an alarm
When an alarm occurs, remove its cause, check that the operation signal is not being inputted, ensure safety,
and reset the alarm before restarting the operation.
Remove the cause of the alarm in accordance with the following manual.
MR-JET User's Manual (Troubleshooting)
The following table shows how to deactivate the alarm.
Alarm deactivation
Alarm reset
Communication reset
Power cycling
Returning from a warning
Some warnings are automatically canceled after the cause is removed, and other warnings are canceled after the cause is
removed and the alarm is reset.
Remove the cause of the warning in accordance with the following manual.
MR-JET User's Manual (Troubleshooting)
Explanation
• Error reset command from the controller
• Click "Occurred Alarm Reset" in the "Alarm Display" window of MR Configurator2.
Disconnect/reconnect network.
• Cycle the power.
• Perform the software reset with commands from the controller and MR Configurator2.
3 BASIC FUNCTION
109
3.9 Alarm function
3