Mitsubishi Electric MELSERVO-JET MR-JET User Manual page 13

I/O, monitor
Functions Detailed functions
DI/DO Input signal selection (device
selection)
Output signal selection (device
setting)
Monitor Power monitoring function
*2
Touch probe Current position latch function
*1 "Ver." indicates the supported firmware version of the servo amplifier. The functions are available on servo amplifiers with the indicated
firmware version or later.
*2 Available on servo amplifiers with firmware version C0 or later and manufactured in July 2022 or later.
Option
Functions Detailed functions
Regenerative Regenerative option
capacity
enhancement
*1 "Ver." indicates the supported firmware version of the servo amplifier. The function is available on servo amplifiers with the indicated
firmware version or later.
Description
This function assigns input devices such as LSP
(Forward rotation stroke end) to certain pins of the
connector.
This function assigns output devices such as MBR
(Electromagnetic brake interlock) to certain pins of
the connector.
This function calculates the running power and the
regenerative power from the data in the servo
amplifier such as speed and current. The power
consumption and other values are displayed on MR
Configurator2.
This function latches the current position when
TPR1 (Touch probe 1), TPR2 (Touch probe 2), or
TPR3 (Touch probe 3) is turned on.
Description
Use this function if the built-in regenerative resistor
of the servo amplifier does not have sufficient
regenerative capacity for the generated regenerative
power.
*1
Ver. Detailed explanation
MR-JET
Page 106 Assigning I/
A4
O devices
A4 Page 106 Assigning I/
O devices
Page 203
A4
MONITORING
C4 Page 145 Touch
probe
*1
Ver. Detailed explanation
MR-JET
Page 107
A4
Regenerative option
selection
1 FUNCTION
1.1 Function explanation
1
11