Launching a test of the connector and fiber end-
face
Launching a test of the connector and fiber end-face
Once the display is correctly adjusted (magnification, sharpness...), a test of fiber
connector can be launched.
To launch the test:
1
Press Test key or Quickcapture
connector.
The test is completed:
–
once the Led Testing is no more lit in red
–
once the icon
–
once a screen as the following one displays:
NOTE
To configure Pass/Fail criteria, see
Figure 35
Test results
A summary of test results is displayed on the right, upper part of the screen.
Launching a test of the connector and fiber end-face
is no more displayed on the upper banner
User Manual
TM
button to launch the test of plugged fiber
"Configuring the Scope" page
74000NG012 Rev. 004
Chapter 6 Scope
49.
Summary of
Test results
Test result in
High mag.
59