Monitoring Mtx3-16-M Hardware - Kramer MTX3-16-M User Manual

Configuring Compression Level
These settings apply to the following input/output cards:
• DTAxrC2-IN2-F34 / DTAxrC2-OUT2-F34
To configure compression level:
•
On the Port Information pane, under XTRA, select one of the following:
▪
Standard
▪
High
Configuring Compression Resolution
These settings apply to the following input/output cards:
•
DTAxrC2-IN2-F34 / DTAxrC2-OUT2-F34
To configure compression level:
•
On the Port Information panel, under XTRA, select one of the following:
▪ >1080P – Compress signal resolutions higher than 1080p.
▪ ALL – Compress all signal resolutions to enable extended reach.

Monitoring MTX3-16-M Hardware

This page enables performing the following actions:
•
Monitoring Temperatures
•
Monitoring Voltages
•
Monitoring Port PoE Providing
•
Monitoring Fans Status
Use the MTX3-16-M
The Status Information Panel –
The left panel on the web pages
has a status information area. If the
panel is hidden, by clicking the X (at
the top), the (green) icons remain
visible and will turn red if a problem
is detected.
MTX3-16-M – Managing MTX3-16-M from the Embedded Web UI
on page 46.
on page 46.
on page 47.
on page 47.
web UI to monitor the status of the control card and matrix cards.
Figure 43: Status Information Panel – Temperature Status
Kramer Electronics Ltd.
45