Step 3:
Hang the Managed Media Converter on the screws from the wall.
Step 4:
Refer to Chapter 2.1.4 Power Information on power supply to the Managed Media Converter.
Before mounting the device to the wall, please check the location of the electrical outlet and the length of the
Ethernet cable.
2.2.3 Media Chassis Installation
To install the Media Converter in a 10-inch or 19-inch standard rack, follow the instructions described below.
Step 1:
Place your Managed Media Converter on a hard flat surface, with the front panel positioned towards your front side.
Step 2:
Carefully slide in the module until it is fully and firmly fitted into the slot of the chassis; the Power LED of the Media
Converter will turn ON.
Figure 2-2: Insert Managed Media Converter into an available slot
20
User's Manual of GT-915A