Step 4: Refer to Chapter 2.4 Power Information on power
supply to the Media Converter.
Before mounting the device to the wall, please
check the location of the electrical outlet and the
length of the Ethernet cable.
Note
3.3 Media Chassis Installation
To install the Media Converter in a 10-inch or 19-inch standard
rack, follow the instructions described below.
Step 1: Place your Media Converter on a hard flat surface, with
the front panel positioned towards your front side.
Step 2: Carefully slide in the module until it is fully and firmly
fitted into the slot of the chassis; the Power LED of the
Media Converter will turn ON.
Figure 3-2: Insert Gigabit Media Converter into an available slot
Ø4mm
XT-705A Switch Bottom Side
17