> 5 sec: Factory Default
2.1.2 Converter LED Indicators
Figure 2-2
shows the LED indications of the Managed Media Converter.
■ System
LED
Color
PWR
Green
■ 1000BASE-X Fiber Optic interface (SFP, SC & WDM)
LED
Color
LNK/ACT
Green
■ 10/100/1000BASE-T Port
LED
Color
LNK/ACT
Green
1000
Green
Speed
Reset the Managed Media Converter to Factory Default
configuration. The Managed Media Converter will then reboot
and load the default settings as below:
。
Default Username: admin
。
Default Password: admin
。
Default IP address: 192.168.0.100
。
Subnet mask: 255.255.255.0
。
Default Gateway: 192.168.0.254
Function
Lights to indicate that the Media Converter has power.
Function
Lights to indicate that the fiber optic link is established.
to indicate that the fiber optic link is actively sending or receiving
Blinks
data over that fiber port.
Function
indicate the link through TP port is successfully established.
Lights to
Blinks to the TP port is actively sending or receiving data
Lights to indicate that the port is operating at 1000Mbps.
Off to indicate that the port is link down or 10Mbps or 100Mbps.
17
User's Manual of GT-915A