Communications Configuration - Ziton ZP2-AF2-P Installation Manual

Chapter 3: Configuration and commissioning

Communications configuration

TCP/IP
Select TCP/IP to configure TCP/IP settings. The default TCP/IP settings are
shown in the table below. The control panel MAC address and Host information
are also available in this screen if required for troubleshooting purposes.
Note:
For increased security, we recommend against using Ethernet for remote
connection to the control panel via the Internet.
Table 30: Default TCP/IP settings
Option Description
IP Configures the IP address
Mask Configures the subnet mask
Gateway Configures the gateway
Port Configures the port
Direct [2] If checked, enables direct email support
DNS Configures the DNS server IP address used for direct
email support
[1] If the default port is changed, the port configuration in the Configuration Utility PC application
must also be updated.
[2] If enabled, settings in Email server have no effect. Requires an Internet connection.
To change the TCP/IP settings:
1. Select Panel setup from the Main menu, and then select Communications.
2. Select TCP/IP.
3. Enter the IP, Subnet mask, Gateway, and Port information.
4. To enable direct email support, check Direct and enter the DNS server IP
address.
5. Press F4 (Enter), and then press F1 (Back).
6. Press F1 (Save), F3 (Apply), F4 (Discard), or F2 (Exit).
Remember to apply saved settings from the Main menu.
Note: If your network is protected by a firewall, the port configuration in your
firewall must be updated to allow local communication with external software.
76
Default value
192.168.104.140
255.255.255.0
0.0.0.0
2505 [1]
Disabled
000.000.000.000
ZP2-A Series Installation Manual