Loop Device Configuration - Ziton ZP2-AF2-P Installation Manual

Loop device configuration

Select Loop device configuration to manually stop or start power for a loop, to
add devices to a loop, or to change the default configuration settings after
autosetup.
To manually stop or start power for a loop:
1. Select Field setup from the Main menu, and then select Loop device
configuration.
All available loops are displayed and their power status indicated (ON).
2. Select the corresponding loop (or select all loops), and then Press F3
(Stop/Start).
If the loop power status is ON, pressing F3 stops the loop (removes all
power). Press F3 again to restart a stopped loop.
3. Press F2 (Exit).
The loop power status for any stopped loops automatically reverts to ON after
pressing F2 to exit the menu (or after two minutes if no button is pressed).
To add a device or to change a device configuration:
1. Select Field setup from the Main menu, and then select Loop device
configuration.
2. Select the corresponding loop and device.
For new devices, a message is displayed.
3. Make the required configuration changes (device type, operating mode, text,
etc.).
4. Press F4 (Enter), and then press F1 (Back).
5. Press F1 (Save), F3 (Apply), F4 (Discard), or F2 (Exit).
Remember to apply saved settings from the Main menu.
ZP2-A Series Installation Manual
Chapter 3: Configuration and commissioning
101