Firenet Configuration - Ziton ZP2-AF2-P Installation Manual

Firenet configuration

Select Firenet to configure the control panel fire network and repeater settings
shown in the table below.
Table 27: Firenet configuration options
Option
Firenet map
Firenet opmode
Repeater map
Global controls
Event filter
Command filter
Class B
Firenet map
The Firenet map defines the control panels included in the fire network. If a
control panel previously configured to be in the fire network is not detected, a
fault message indicating the offline status (with the Firenet ID) is reported.
To change the Firenet map settings:
1. Select Panel setup from the Main menu.
2. Select Firenet.
3. Select Firenet map.
A list of detected control panels appears on the LCD.
4. Select the control panel from the list, and then select YES (to add the control
panel to the network) or NO (to remove the control panel from the network).
5. Press F4 (Enter), and then press F1 (Back).
6. Press F1 (Save), F3 (Apply), F4 (Discard), or F2 (Exit).
Remember to apply saved settings from the Main menu.
ZP2-A Series Installation Manual
Description
Displays all detected control panels, to add control panels to the
fire network, or to remove control panels from the network. By
default new control panels detected do not communicate with the
network.
Configures the control panel network operation mode (stand-alone
panel, networked panel, or networked repeater panel).
Configures the control panels in the network that the control panel
being configured will repeat.
Configures global control options for networked control panels and
repeaters.
Configures the types of events to repeat from other control panels
in the fire network.
Configures the types of commands sent to the fire network in
control panels with the corresponding global controls configured.
Configures a Class B network. When this option is configured, no
fault is reported for an open network.
Chapter 3: Configuration and commissioning
71