EDAN DUS 60 User Manual page 50

DUS 60 Digital Ultrasonic Diagnostic Imaging System User Manual
7.1.11. FTA
To measure FTA:
1. Press Measure to activate obstetric measurement.
2. In the obstetric menu, roll the trackball to highlight the menu FTA, press Set, and move the
cursor to image and display "+".
3. Measure FTA, in the method of ellipse or trace area measurement.
Reference Section 6.6.1, Generic Measurements in B Mode
4. The results are displayed in measurement result window.
5. To begin a new FTA measurement, repeat steps 1 through 3. You can measure a maximum of
one group of data.
7.1.12. HUM
To measure HUM:
1. Press Measure to activate obstetric measurement.
2. In the obstetric menu, roll the trackball to highlight the menu HUM, press Set, and move the
cursor to image and display "+".
3. Measure HUM, in the method of distance measurement.
Reference Section 6.6.1, Generic Measurements in B Mode
4. The results are displayed in measurement result window.
5. To begin a new HUM measurement, repeat steps 1 through 3. You can measure a maximum
of one group of data.
7.1.13. OFD
To measure OFD:
1. Press Measure to activate obstetric measurement.
2. In the obstetric menu, roll the trackball to highlight the menu OFD, press Set, and move the
cursor to image and display "+".
3. Measure OFD, in the method of distance measurement.
Obstetric Measurements and Calculations
- 90
-
DUS 60 Digital Ultrasonic Diagnostic Imaging System User Manual
Reference Section 6.6.1, Generic Measurements in B Mode
4. The results are displayed in measurement result window.
5. To begin a new OFD measurement, repeat steps 1 through 3. You can measure a maximum of
one group of data.
7.1.14. THD
To measure THD:
1. Press Measure to activate obstetric measurement.
2. In the obstetric menu, roll the trackball to highlight the menu THD, press Set, and move the
cursor to image and display "+".
3. Measure THD, in the method of distance measurement.
Reference Section 6.6.1, Generic Measurements in B Mode
4. The results are displayed in measurement result window.
5. To begin a new THD measurement, repeat steps 1 through 3. You can measure a maximum of
one group of data.
7.1.15. FBP
To measure AF:
1. Press Measure to activate obstetric measurement.
2. In the obstetric menu, roll the trackball to highlight the menu FBP, select AF and press Set.
3. Measure AF, in the method of distance measurement.
Reference Section 6.6.1, Generic Measurements in B Mode
4. The results are displayed in Measured Results window.
5. To begin a new AF measurement, repeat steps 1 through 3. Otherwise the system will return
to the default measurement of TAD.
Fetal Biophysical Profile
1. Press Measure to activate obstetric measurement.
2. In the obstetric menu, roll the trackball to highlight the menu FBP, select Key In and press
Set.
Obstetric Measurements and Calculations
- 91
-