Cx-L; Ut-L/Cx-L; Measurements And Calculations In Pw Mode; L Ut A - EDAN DUS 60 User Manual

DUS 60 Digital Ultrasonic Diagnostic Imaging System User Manual

9.1.5. CX-L

To measure CX-L:
1. In the gynecology measurement menu, roll the trackball to CX-L, and press Set.
2. Measure CX-L with distance method.
Reference Section 6.6.1, Generic Measurements in B Mode
3. The result will be displayed in the measurement result window, if you have already measured
UT-L, the UT-L/CX-L will also be displayed.

9.1.6. UT-L/CX-L

To measure UT-L/CX-L:
1. In the gynecology measurement menu, roll the trackball to highlight UT-L/CX-L, and press
Set.
2. Measure UT-L and CX-L, in the method of distance measurement.
Reference Section 6.6.1, Generic Measurements in B Mode
3. The results will be displayed in the measurement result window.
NOTE:
During measurement, if you have already measured any one of the items, UT-L or CX-L,
when you finished the other one, the UT-L/CX-L will be displayed automatically.

9.2. Measurements and Calculations in PW Mode

1. Press Exam and select Gynecology, and then press Set.
2. Press to enter the PW mode.
3. Press Measure to activate the measurement function. The system displays the measurement
menu shown as below.
Items of Measurement and Calculation
L UT A, R UT A, L OV A, and R OV A.
Gynecology Measurements and Calculations
- 120
-
DUS 60 Digital Ultrasonic Diagnostic Imaging System User Manual
Figure 9-2 Gynecology Measurement and Calculation Menu in PW Mode
Label Description

L UT A

Left Uterus Aorta

R UT A

Right Uterus Aorta
L OV A Left Ovary Aorta
R OV A Right Ovary Aorta
Table 9-2 Gynecology Measurement and Calculation Items in PW Mode
9.2.1. L UT A:
1. Press Measure to activate the measurement.
2. In the gynecology measurement menu, select L UT A.
3. Measure L UT A, in the method of D trace measurement.
Reference Section 6.6.3, Generic Measurements in PW Mode
4. The results are displayed in measurement result window.
5. You can measure a maximum of one group of data. To begin a new L UT A measurement,
repeat steps 1 through 3.
9.2.2. R UT A:
1. Press Measure to activate the measurement.
2. In the gynecology measurement menu, select R UT A.
3. Measure R UT A, in the method of D trace measurement.
Reference Section 6.6.3, Generic Measurements in PW Mode
4. The results are displayed in measurement result window.
5. You can measure a maximum of one group of data. To begin a new R UT A measurement,
repeat steps 1 through 3.
Gynecology Measurements and Calculations
Secondary menu of the gynecology
measurement items in the PW
mode:
Channel Method
1
1
D trace
1
1
- 121
-