Check Counting - KERN CDS 4K0.02 Operating Instructions Manual

9.2.7 Check counting

With the <Check counting> application you can check if the weighing good is within
a predefined tolerance range.
When limit values are exceeded below or above, an acoustic signal (if enabled in
menu) will sound and an optical signal (tolerance marks) will be displayed
Optical signal:
The tolerance marks provide the following information:
Acoustic signal:
The acoustic signal depends on the menu setting
< setup  beeper >, see chap. 10.3.1.
TCDS-BA-e-2210
Target quantity exceeds defined tolerance
Target quantity within defined tolerance
Target quantity below defined tolerance
34