Check Counting - KERN FKB 6K0.02 Operating Instructions Manual

11.2.2 Check counting

The balance allows weighing of goods within set tolerances in keeping with a
determined target quantity. With this function one can also check if the weighing
good is within a defined tolerance range.
Reaching the target value is indicated by an acoustic (if activated in menu) and an
optic signal (tolerance marks
Optical signal:
The tolerance marks provide the following information:
Acoustic signal:
The acoustic signal depends on the menu setting
< setup >  < beeper > , see chap. 13.3.1.
Procedure:
1. Define target quantity and tolerances
TFKB_B-BA-e-2210
Target quantity exceeds defined tolerance
Target quantity within defined tolerance
Target quantity below defined tolerance

Make sure that the scale is in counting mode and that an
average piece weight has been defined (see chap. 11.2).
If necessary, switch over with the
).
key.
39