Application <Counting; Application-Specific Settings - KERN CDS 4K0.02 Operating Instructions Manual

9 Application <Counting>

9.1 Application-specific settings

Call up menu:

Press the TARE key and hold it until<apcmen> is displayed.

The display changes to <coumod> followed by <ref>.

Navigation in menu see chap. 10.1
Overview:
Level 1 Level 2
Ref :
Reference
quantity
actuAl
Ptare
PRE-TARE
manuAl
CLEAR
Unit
available weighing units,
see chap. 1
Units
Free factor
target value
Check
Check
counting
limit
25
Description / Chapter
5
Reference quantity 5
10
Reference quantity 10
20
Reference quantity 20
50
Reference quantity 50
free
Optional, numeric input, see chap.
3.2.2.
input
Input piece weight
Take over the placed weight as PRE-
TARE value, see chap. 9.2.4
Numerical input of the tare weight, see
chap. 9.2.5
Delete PRE-TARE value
This function is used to define which
weighing unit is to be used in the
weighing balance.
Multiplication factor
Target value entry
errupp
Upper tolerance
errlow
Lower tolerance
reset
Reset settings to factory defaults
Upper limit value for target piece
limupp
quantity, numeric input see chap. 3.2.2
Lower limit value for target piece
limlod
quantity, numeric input see chap. 3.2.2
reset
Reset settings to factory defaults
TCDS-BA-e-2210