Table of Contents
Advertisement
8.8.2 Check counting
The <Test counting> application enables to determine the upper and lower limit
value and, consequently, to ensure that the target number of pieces belongs to the
range between the determined tolerance limits.
When the target value is achieved, the sound is heard and an optical signal is visible
(tolerance symbols
Setting conditions of sending and limits:
Using the UNIT button, select the application unit [pcs].
<
> will be displayed.
Press ZERO and hold it for 3 s, <inside> will be displayed.
Using the ZERO button, select the required signaling condition. For selection
options see chapter 8.8.1 / step 2:
Confirm the selection by pressing
The window for value entry in the numerical form will be displayed where you
can enter the lower limit value. The tolerance symbol
active item is blinking.
Enter the lower limit value (for entering the numerical value see chapter 3.2.1)
and confirm.
<
> will be displayed for a while. The window for value entry in the
numerical form will be displayed where you can enter the upper limit value. The
tolerance symbol
Enter the upper limit value (for entering the numerical value see chapter 3.2.1)
and confirm.
<
> will be displayed for a while, the scale will switch to the weighing mode
again.
Tolerance check start:
Ensure the average weight of a single piece is determined (see chapter 8.7.)
Place the weighed material (< 20 d) and, based on the tolerance symbols / audible
signal, check if the weighed material belongs to the preset tolerance range.
Weighed material
below
the preset tolerance
• To cancel the limit values, enter <00000>.
• Deactivate the test weighing mode. To do it, press TARE and hold it long
enough for <
24
,
,
).
, <
will be displayed, the active item is blinking.
Weighed material
in the preset tolerance
> to be displayed.
> will be displayed for a while.
will be displayed, the
Weighed material above
the preset tolerance
TFCD_A-BA-e-2110
Advertisement
Table of Contents
