10 Check counting
The scales enables to weigh materials to the specific target number of pieces in the
preset tolerance range. This function enables also to check if the weighed material
belongs to the preset tolerance range.
Achieving the target value is indicated by an audible signal (if enabled in the menu)
and a visual signal (tolerance symbol
Visual signal:
Tolerance symbols provide the following information:
The target number of pieces above the preset tolerance
The target number of pieces in the preset tolerance range
The target number of pieces below the preset tolerance
Audible signal:
The audible signal depends on the
<beeper check> menu item, see chapter 11.2.1.
You can choose:
Tolerance check type
Ch-ok
The audible signal sounds
when the target number of
pieces belongs to the preset
tolerance range
Ch-lo
The audible signal sounds
when the target number of
pieces is lower than the
preset tolerance range
CKE-BA-e-2031
,
,
)
Audible signal settings
off
Slow beep
Standard
beep
Fast beep
Cont. beep
off
Slow beep
Standard
beep
Fast beep
Cont. beep
The audible signal is off
Slow
Standard
Fast
Continuous
The audible signal is off
Slow
Standard
Fast
Continuous
19