Removing The Front Bezel; Figure 18 Removing The Front Bezel - Nortel Contivity 2600 Getting Started

Hide thumbs Also See for Contivity 2600:

Table of Contents

46 Chapter 4 Changing Hardware Configurations

Removing the front bezel

You must remove the bezel to insert the recovery diskette. Note that you do not

need to turn off the Contivity if you are only removing the front bezel.

shows you how to remove the front bezel from the Contivity.

Warning: When handling the Contivity outside of the rack-mount

shelf, do not use the piece with the Nortel Networks logo and the LEDs

as a handle.

Note that the first few times you remove the front bezel it might seem to resist

removal. This is simply because the ball studs and socket clips are new. After a

few times, removal is easier.

To remove the front bezel, you need a Phillips screwdriver.

Using the screwdriver, turn each of the two screws on the front bezel a quarter

turn counter-clockwise.

Grip the two handles and firmly pull the bezel towards you to unsnap it from

the chassis.

311120-B Rev 00

Figure 18

CS260015A

Table of Contents