Nortel Contivity 2600 Getting Started page 53

To install a DIMM, follow these steps.
1
Turn off the Contivity.
2
Remove the power cord.
3
Remove the front bezel as shown in
4
Remove the top cover as shown in
5
Press down the locking levers on both sides of the DIMM.
6
Pull the DIMM up to remove it from the slot.
7
Place a new DIMM in the slot, making sure to properly position the DIMM's
alignment keys. Make sure the DIMM is pressed firmly into the socket.
8
Pull up the locking levers on both sides of the DIMM, and snap in the DIMM,
as necessary.
9
Replace the top cover.
10 Replace the front bezel.
Chapter 4 Changing Hardware Configurations 53
Figure 18.
Figure 19.
Getting Started with the Contivity 2600