Understanding the LEDs
Front panel LEDs
The front panel, shown in
LEDs. These LEDs indicate the status of the Contivity Extranet Switch.
Figure 9 The front panel LEDs
•
The Power LED is the lighted Nortel Networks logo. It is blue when the
power is on.
•
The triangular Alert/Fail LED is set to yellow or red by the Contivity
Extranet Switch software. Yellow indicates a non-fatal status requiring
attention. Red indicates hardware errors that also cause the beeping condition.
While both conditions require attention, red indicates more serious errors.
This LED indicates the Health Check status that is described in Health Check
reports. Refer to Managing the Contivity Extranet Switch for information on
Health Check.
•
The Boot/Ready LED displays yellow or green. Yellow indicates a boot in
process/non-ready state. A steady green indicates the box has reached a state
of readiness. The Boot LED lights at power up and is changed to green when
the software is ready.
Figure
Alert/Fail
Boot/Ready
Chapter 2 Cabling and LEDS 33
9, has a lighted Nortel Networks logo, and 2
Power
Alert/Fail
Boot/Ready
CS160013A
Getting Started with the Contivity 2600