Connectcorewi-9C Configurations; Configuration Diagrams - Digi ConnectCore 9C Hardware Reference Manual

A B O U T T H E M O D U L E S
1

ConnectCoreWi-9C configurations

C o n n e c t C o r e W i - 9 C c o n f i g u r a t i o n s
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
The ConnectCore Wi-9C module is available in these base configurations:




Additional population options are available. For information, contact your local Digi
sales office or distributor.
The diagrams in this section show configurations for the ConnectCore Wi-9C
Configuration
module, illustrated with top and edge views.
diagrams
ConnectCore 9C/Wi -9C Hardware Reference, Rev D 05/2010
8
Fully populated, 2xRP-SMA. A fully populated module using RP-SMA includes
on-board Ethernet PHY, Ethernet magnetics with RJ-45, a USB hub and Type A
female connector, and two RP-SMA connectors.
With Ethernet, without USB, and with single RP-SMA. With this setup,
Ethernet PHY or Ethernet magnetics with RJ-45 are on the module. The module
does not have an on-board USB hub and Type A female connector. There is one
RP-SMA connector.
No additional on-board connectors, with single RP-SMA. With this setup,
there is no Ethernet RJ-45 with integrated magnetics on the module.There is
one RP-SMA connector with the Ethernet PHY. The module does not have an on-
board USB Hub and Type A female connector.
Modules without an on-board Ethernet connector provide the Ethernet
Note:
PHY signals through the SO-DIMM edge connector.
With Ethernet, without USB, and with 2xU.FL. With this setup, Ethernet PHY
or Ethernet magnetics with RJ-45 are on the module. The module does not
have an on-board USB hub and Type A female connector, although USB Host and
Device signals are available on the edge connector. There are two
U.FLconnectors.