L3 Parameters Setting - KUNTENG KT-LCD10H User Manual

ELECTRIC BICYCLE METER KT—LCD10H Product User Manual
When L2=0, P1 parameter is set as the calculated value.
When L2=1, P1 parameter is set as a half of the calculated value.
After finishing L2 parameter setting, press
value and then enter L3 parameter setting interface.
○
L3 Parameter setting
L3 parameter is applicable to the dual mode controller. The default of the factory
is 1.
When L3=0, the controller will activate Non-Hall model only when the Hall
sensor in the motor fails
When L3=1, the controller will choose the proper model to use according to
the controller system optimization.
After finishing L3 parameter setting, hold
exit L parameter setting environment and return to the display 1
○
Exit Parameter Setting
Among the fourteen C parameter settings, when each parameter setting is completed,
if held button (SW) long for about 2 seconds, all can exit the setting environment
and return to display 1, meanwhile, the current set parameters would be saved.
button (SW) to save the current
button (SW) for about 2 seconds to
- 38 -